Homeowner guide
Burst Pipes and Frozen Pipes: What to Do Right Now and How to Prevent Them
What to do when a pipe bursts: shut off the water, cut power to wet areas, document and dry. Plus which pipes freeze, how to thaw them and how to prevent it.
Call (855) 742-6216Quick answer
If a pipe bursts, shut off the main water valve immediately, then turn off electricity to wet areas if you can reach the panel safely. Open faucets to drain the lines, move belongings, photograph the damage and call a plumber and your insurer. Start drying right away. Pipes most likely to freeze are in exterior walls, attics, crawlspaces and garages; keeping heat on and letting faucets drip helps prevent freezing.
Do this first: the 5-minute emergency plan
- Shut off the main water valve. Turn a round handle clockwise until it stops, or turn a lever a quarter turn so it sits across the pipe.
- Turn off electricity to the affected area if water is near outlets, fixtures or the panel and you can reach the panel from a dry spot. Otherwise, stay out and call an electrician or your utility.
- Open the faucets nearest the break, both hot and cold, to drain remaining water and relieve pressure.
- Turn off the water heater (power or gas) if the house will be without water for a while.
- Catch and remove water with buckets, towels and a wet/dry vacuum.
Then call a plumber to repair the pipe. A burst pipe often releases a lot of clean water quickly, so the water damage can be serious even after the leak stops.
Find your shutoff valve before you need it
Every adult in the home should know where the main shutoff is. Common locations:
| Home type | Where to look |
|---|---|
| Basement home | On the front foundation wall where the main line enters, often near the water meter |
| Slab home (no basement) | Near the water heater, in a utility closet, garage, or under a kitchen sink |
| Warm-climate homes | Outside, on an exterior wall or in a box near the street or front yard |
| Crawlspace home | Inside the crawlspace near where the line enters |
| Condo or apartment | Inside the unit near the water heater or kitchen, or a shared valve your building manages |
The water meter box at the curb also has a valve, but it may belong to the utility and require a special key. Test your main valve once a year so it is not stuck when it matters.
After the water stops: limit the damage
- Photograph and video everything before cleanup, including the broken pipe.
- Keep the damaged section of pipe after the plumber removes it. Your insurer may want it.
- Move furniture and rugs off wet floors and lift drapes.
- Open cabinet doors under sinks and in affected areas.
- Look below. Water from an upstairs pipe often travels to ceilings and walls on the floor below.
- Call your insurance company to report the loss.
- Start drying with dehumidifiers and air movers, or call a professional.
Water from a supply pipe is usually Category 1 (clean) at first under the IICRC S500 standard, which means many materials can be dried in place if drying starts quickly. Waiting allows it to degrade. See water categories and classes and how long drying takes.
Why frozen pipes burst
Water expands as it freezes. Many people assume the ice itself splits the pipe at the frozen spot. More often, according to the American Red Cross and building researchers, an ice blockage traps water between the ice and a closed faucet. As more ice forms, pressure in that trapped section builds until the pipe fails, sometimes at a spot that never froze.
This explains two things:
- A dripping faucet helps, because it relieves pressure in the line.
- A pipe can burst during the freeze but not leak until it thaws. Many homeowners discover the damage when temperatures rise.
Which pipes are most likely to freeze
The Red Cross and other safety organizations point to pipes exposed to cold air:
- Outdoor hose bibs, swimming pool supply lines and sprinkler lines
- Pipes in unheated areas: basements, crawlspaces, attics, garages and kitchen cabinets on exterior walls
- Pipes that run along exterior walls with little or no insulation
- Pipes near drafts, such as dryer vents, foundation cracks or poorly sealed windows
- Pipes in vacant or seasonal homes where the heat was turned down
Homes in warmer regions can actually be more vulnerable during a rare hard freeze, because pipes are more often run through uninsulated spaces.
How to tell if a pipe is frozen and how to thaw it
If you turn on a faucet and only a trickle comes out, or nothing at all, during a cold snap, suspect a frozen pipe.
- Keep the faucet open. Flowing water helps melt ice and relieves pressure.
- Apply gentle heat to the frozen section with a hair dryer, an electric heating pad, a portable space heater kept away from flammables, or towels soaked in hot water.
- Work from the faucet back toward the frozen area.
- Keep heating until full water pressure returns.
- Check other faucets; if one pipe froze, others may have too.
Never use an open flame, propane torch, kerosene heater or charcoal stove to thaw pipes. The Red Cross warns against this because of fire and carbon monoxide risks. If you cannot find or reach the frozen section, call a licensed plumber.
How to prevent frozen and burst pipes
Before winter:
- Drain and disconnect garden hoses; shut off and drain outdoor faucets from the inside valve if you have one.
- Insulate pipes in attics, crawlspaces and garages with foam pipe sleeves.
- Consider UL-listed heat tape or heat cable for exposed pipes, installed according to the manufacturer's directions.
- Seal gaps where cold air enters near pipes.
- Drain swimming pool and sprinkler supply lines according to the installer's directions.
During cold snaps:
- Let cold water drip from faucets served by exposed pipes.
- Open kitchen and bathroom cabinet doors so warm air reaches the plumbing.
- Keep garage doors closed if water lines run through the garage.
- Keep the thermostat at the same temperature day and night.
When away: the Red Cross recommends leaving the heat on and set no lower than 55 degrees Fahrenheit. For long absences, consider shutting off and draining the water system. Check what your insurance policy requires; many require heat to be maintained or the system drained.
Where the pipe burst changes the response
| Location | What to watch for | Typical response |
|---|---|---|
| Inside a ceiling | Sagging or bulging drywall holding water | Keep people out from under it; a pro may poke a small hole to drain it into a bucket in a controlled way |
| Inside a wall | Wet baseboards, bubbling paint, water on the floor along the wall | Wall opened to repair the pipe; cavity dried or insulation removed |
| Under a slab (slab leak) | Warm spots on the floor, sound of running water, high water bill | Plumber locates and repairs or reroutes; flooring may need to come up |
| In a crawlspace | Standing water, musty smell, damp subfloor | Water removed, vapor barrier checked, crawlspace dried |
| Attic | Stains spreading on ceilings, wet insulation | Wet insulation removed and ceiling drywall checked |
| Outside hose bib | Water inside the wall behind the spigot | Often found in spring when the hose is first used |
Other common causes of pipe and hose bursts
Freezing is not the only cause. Other frequent sources of sudden water damage include:
- Washing machine supply hoses. Rubber hoses can crack and split with age. Braided stainless steel hoses are a common upgrade; follow the manufacturer's replacement guidance.
- Toilet and faucet supply lines. Plastic nuts and old lines can fail without warning.
- High water pressure. Excess pressure strains pipes and fittings. A plumber can test it and install or adjust a pressure-reducing valve.
- Corrosion. Older galvanized steel pipes corrode from the inside.
- Polybutylene pipe. This gray plastic pipe, used in many homes built from the late 1970s to the mid-1990s, has a well-documented history of failures. Many insurers and plumbers recommend replacing it.
Automatic leak detectors and shutoff valves can stop the water within moments of a leak. Some insurers offer discounts for them; ask your agent.
Burst pipes and insurance
A burst pipe is typically covered under a standard homeowners policy as a "sudden and accidental discharge" of water. Policies usually cover the water damage and the cost to open walls to reach the pipe, but not the pipe repair itself.
Freeze damage may be excluded if the home was vacant or unheated and you did not shut off and drain the water. See does homeowners insurance cover water damage for details.
A burst pipe can release a lot of water fast. Call (855) 742-6216 to be connected with an independent local company that handles burst pipe water damage, day or night.
Frequently asked questions
What is the first thing to do when a pipe bursts?
Shut off the main water valve. That stops new water from flowing. Then turn off electricity to wet areas if you can safely reach the breaker panel, open faucets to drain the lines, and start removing water. Call a plumber to repair the pipe and your insurance company to report the damage.
At what temperature do pipes freeze?
Water freezes at 32 degrees Fahrenheit, but pipes inside a home usually need a prolonged stretch of colder outdoor temperatures to freeze. Risk depends on how exposed the pipe is, insulation, wind and how long the cold lasts. Pipes in attics, crawlspaces, garages and exterior walls freeze first. During hard freezes, drip faucets and keep the heat on.
Should I let my faucets drip in cold weather?
Yes, for faucets served by pipes in cold or exposed areas. The Red Cross recommends letting cold water drip during extreme cold. Running water is harder to freeze, and an open faucet relieves pressure that builds between an ice blockage and the faucet, which is what usually causes pipes to burst.
How do I know if a frozen pipe has burst?
Signs include water stains, dripping or spraying sounds, puddles, bulging drywall, a sudden drop in water pressure, or the water meter spinning when nothing is running. Often the leak appears only after the pipe thaws. Keep the main valve location handy when thawing pipes so you can shut it off fast if a leak starts.
How long does it take to dry out after a burst pipe?
For clean water from a supply pipe, professional drying commonly takes about three to five days, depending on how much got wet and what materials are involved. Hardwood, plaster and concrete take longer. Drying should continue until moisture meter readings match unaffected areas, not just until surfaces feel dry.
Does insurance cover a pipe that froze and burst?
Typically yes, if the home was heated or you took reasonable steps to prevent freezing. Many policies exclude freeze damage in vacant or unheated homes unless the water was shut off and drained. Coverage usually includes the resulting water damage but not the pipe itself. Read your policy's freezing clause.
Related services
More guides
- What to Do After Water Damage: The First 24 to 48 Hours, Step by Step
- Water Damage Categories (1, 2, 3) and Classes (1 to 4) Explained
- Does Homeowners Insurance Cover Water Damage? What Is Covered and What Is Not
- How to File a Water Damage Insurance Claim, Step by Step
- Flood Insurance Explained: Flood vs Water Damage, the NFIP and Private Flood
- How Long Does It Take to Dry Water Damage? The Process, Equipment and Timelines
- Mold After Water Damage: Why 24 to 48 Hours Matters and When to Call a Pro
- The Mold Remediation Process: What Professionals Do, Step by Step
- Sewage Backup in Your Home: Causes, Health Risks and What to Do
- Sump Pump Failure and Basement Flooding: Why Pumps Fail and What to Do
- What to Do After a House Fire: Safety, Insurance and Recovery, Step by Step
- Smoke Odor Removal: Soot Types, Cleaning Methods and What Actually Works
- How to Choose a Water, Fire or Mold Restoration Company
- What Drives Water Damage Restoration Cost (and How It Is Billed)
- Storm Damage Checklist: What to Do Before and After a Hurricane or Severe Storm
- Signs of a Hidden Water Leak: How to Find Leaks Behind Walls and Under Floors
- What Can Be Saved After Water Damage? A Material-by-Material Guide
Get restoration help
Water, flood, mold, fire, smoke and storm damage. Many local companies answer around the clock.
Call (855) 742-6216