(855) 742-6216

Restoration services

Basement Flooding & Water Removal

Basements flood more often than any other part of a home because they sit below ground, next to the water table, the sewer line and the sump pit. A few inches of water can ruin finished walls, carpet, stored belongings and mechanical equipment like the furnace and water heater. And because basements are cool and humid, wet materials there are especially prone to mold.

The Restoration Resource is a free referral service, not a restoration company. Call (855) 742-6216 and we will connect you with an independent local restoration company that can remove the water, dry the space and help you understand what caused it. Many of these companies offer 24/7 emergency response.

Call (855) 742-6216Free referral service for homeowners

When you need basement flooding & water removal

Why Basements Flood: Common Causes

Finding the cause matters for two reasons: it tells the crew how contaminated the water is, and it often decides whether insurance will help.

CauseWhat you might seeWater type (IICRC)
Sump pump failure or power outageWater rising from the sump pit during heavy rainUsually Category 2; can be worse
Groundwater seepage (hydrostatic pressure)Water at the wall-floor joint or through cracksUsually Category 2
Sewer or drain backupDirty water and odor coming up a floor drain or toiletCategory 3
Surface floodingWater entering through window wells, doors or walls during a floodCategory 3
Burst pipe or supply lineClean water spraying or pooling near plumbingCategory 1 at first
Water heater or washer failureWater pooling around the applianceCategory 1 or 2
Poor drainage outsideWater after storms near short downspouts or low soilUsually Category 2

Water categories come from the IICRC S500 standard. Clean water can degrade to a worse category over time. See our guide on sump pump failure and basement flooding.

How Professionals Remove Water and Dry a Basement

A restoration crew working to the IICRC S500 standard will typically:

  1. Check safety. Water in a basement can reach outlets, extension cords, the furnace and the electrical panel. The crew confirms power is safe before entering.
  2. Find and stop the source, or recommend a plumber, waterproofing contractor or sewer company if the cause needs repair.
  3. Pump out standing water with submersible or trash pumps, then extract remaining water from carpet and floors.
  4. Map moisture in walls, framing, subfloor and concrete with meters and thermal cameras.
  5. Remove unsalvageable materials such as carpet pad, wet insulation and lower drywall, often with a flood cut.
  6. Clean and disinfect when the water was Category 2 or 3.
  7. Dry the structure with dehumidifiers and air movers. Concrete holds a lot of moisture, so basements often need strong dehumidification.
  8. Monitor and document moisture readings until drying goals are met.

Repairs, such as new drywall and flooring, come after the space is confirmed dry.

Equipment Used in Basement Water Removal

Basement drying often runs longer than above-grade drying because concrete and block walls release moisture slowly. Cool basement air also holds less moisture, so the crew may add heat or use desiccant dehumidifiers to keep drying on track. Ask to see the daily readings so you know progress is real.

What Can Be Saved in a Flooded Basement

The answer depends mostly on the water type and how long it sat.

ItemClean water, dried quicklySewage or floodwater
Wall-to-wall carpetSometimes savedDiscarded
Carpet padUsually replacedDiscarded
Drywall and insulationDrywall may be dried; wet insulation usually removedRemoved above the water line
Vinyl plank or tile flooringOften saved; water under it must be checkedCleaned and disinfected or replaced
Cardboard boxes and paperOften lostDiscarded
Plastic storage bins (sealed)Contents usually fineBins cleaned and disinfected
Furnace, water heater, appliancesHave a technician inspect before useHave a technician inspect; some must be replaced

Do not restart gas appliances or a furnace that was underwater until a qualified technician checks them. See what can be saved after water damage.

Finished vs. Unfinished Basements

The same few inches of water can mean very different jobs depending on how the basement is built out.

Basement typeWhat usually happensMain concern
Unfinished (bare concrete, open framing)Pump out, clean, disinfect if needed and dry with dehumidifiersConcrete holding moisture; stored items on the floor
Partly finished (carpet or some framed walls)Carpet and pad often removed; lower drywall checked and sometimes cutHidden water behind walls and under flooring
Fully finished (drywall, insulation, built-ins, bathroom)Flood cuts, insulation removal, cabinet and flooring removal, full structural dryingMold inside wall cavities; more materials to rebuild

In finished basements, framing often sits directly on the concrete slab, where it wicks water up quickly. Insulation and vapor barriers on foundation walls can trap moisture, so a crew may need to open walls even when the drywall looks fine. If you plan to refinish after the cleanup, ask about moisture-resistant materials, such as closed-cell foam insulation, mold-resistant drywall and flooring that tolerates water.

Before rebuilding, the cause of the flooding should be fixed. Otherwise the next heavy rain or pump failure can ruin the new finishes.

Health and Safety in a Wet Basement

Does Insurance Cover a Flooded Basement?

It depends entirely on the cause and on your policy. In general terms:

Take photos before cleanup and report the loss quickly. Read does homeowners insurance cover water damage and our NFIP guide.

What Affects the Cost of Basement Water Removal

Our cost guide explains how restoration estimates are written.

Choosing a Company and What to Do While You Wait

When choosing a company, ask about IICRC certification, proof of insurance, a written scope with moisture readings and estimates written in Xactimate or a similar format your insurer can review. Read any assignment of benefits form carefully before you sign it. More in our guide to choosing a restoration company.

While you wait:

Don't use a household vacuum on water, run gas appliances that got wet, or open walls yourself when sewage is involved. To reach a local company, call (855) 742-6216.

How to Prevent Basement Flooding

How it works

  1. Call (855) 742-6216Tell us what happened (water, flood, mold, fire or storm) and where the property is.
  2. Get connectedWe connect your call with an independent restoration company serving your area.
  3. Get it handledThe company inspects, explains the scope in writing and works with you and your insurer. You decide whether to go ahead.

Frequently asked questions

What should I do first if my basement floods?

Stay out of the water until you know the power is off or safe. If you can reach the breaker from a dry spot, shut off power to the basement. Stop the source if possible, photograph the damage, move valuables to a dry area and call your insurer. Then get a restoration company to pump out the water and start drying.

Can I pump out my basement myself?

For small amounts of clean water, a wet/dry vacuum or a rented pump can help. Be careful with deep water: if the ground outside is still saturated, pumping too fast can let groundwater pressure push on the walls. And if the water came from a sewer or flood, it is Category 3 and should be handled by a crew with protective gear.

Does homeowners insurance cover sump pump failure?

Usually not unless you have a water backup and sump discharge or overflow endorsement on your policy. Standard homeowners policies typically exclude water that backs up through drains or overflows from a sump. Check your declarations page or ask your agent whether you have this add-on.

How long does it take to dry a flooded basement?

It depends on how much water there was, whether the basement is finished and how humid it is. Concrete floors and block walls release moisture slowly, so basements often take longer to dry than upper floors. A professional crew tracks moisture readings and stops drying only when materials reach their drying goals.

Will my basement get moldy after flooding?

It can. According to the EPA, mold can begin growing on damp materials within 24 to 48 hours. Basements are often cool and humid, which makes fast drying and dehumidification especially important. If mold has already appeared, see our page on mold remediation.

Why does my basement flood every time it rains?

Common reasons include short or clogged downspouts, soil that slopes toward the house, clogged or missing drain tile, a sump pump that is too small or failing, and cracks in the foundation. Repeated seepage is usually a waterproofing or drainage issue, so a waterproofing contractor or plumber may be needed in addition to cleanup.

Related guides

Basement Flooding & Water Removal by city

All 4,173 locations →

Other restoration services

Get restoration help

Water, flood, mold, fire, smoke and storm damage. Many local companies answer around the clock.

Call (855) 742-6216
Call (855) 742-6216