(855) 742-6216

Restoration services

Burst Pipe Water Damage

A burst pipe can release a large amount of water in a short time, and it often happens inside a wall, ceiling or crawlspace where you cannot see it. The water you notice on the floor is usually only part of the problem. The rest soaks into drywall, insulation, subfloors and the ceiling below.

First, shut off your main water valve. Then call a plumber to fix the pipe, and get a restoration company to remove the water and dry the structure. The Restoration Resource is a free referral service, not a restoration company. Call (855) 742-6216 and we will connect you with an independent local restoration company. Many offer 24/7 emergency response.

Call (855) 742-6216Free referral service for homeowners

When you need burst pipe water damage

What to Do Right Now When a Pipe Bursts

  1. Shut off the main water valve. It is often where the water line enters the house, near the water heater, in the basement, in a utility closet or near the meter.
  2. Turn off electricity to wet areas if you can reach the breaker from a dry spot. Never touch the panel while standing in water.
  3. Open faucets to drain the remaining water out of the lines and relieve pressure.
  4. Turn off the water heater if the water supply is shut off for a while, following the manufacturer's instructions.
  5. Get out of the way of sagging ceilings. A ceiling holding water can collapse. Keep people out of the room below.
  6. Document everything with photos and video, including the broken pipe.
  7. Call a plumber to repair the pipe and a restoration company to dry the structure. These are usually two different trades.
  8. Report the loss to your insurance company.

Keep the broken section of pipe. Your adjuster may want to see it. More steps in our guide on what to do after water damage.

Why Pipes Burst

Pipes most often burst from freezing, but age, pressure and corrosion also play a role.

Frozen pipes often do not leak until they thaw. Check for water as temperatures rise. See our guide on burst pipes and frozen pipes.

How Restoration Pros Handle Burst Pipe Damage

The water from a supply line starts out clean (Category 1 under the IICRC S500 standard), which means much more can often be dried and saved if drying starts fast. A typical job includes:

  1. Inspection and moisture mapping with moisture meters and thermal imaging, to follow water through walls, ceilings and floors below.
  2. Extraction of standing water and water held in carpet.
  3. Controlled demolition only where needed: removing ceiling drywall holding water, wet insulation, or small holes for drying wall cavities.
  4. Structural drying with dehumidifiers, air movers and, when useful, systems that push dry air into wall cavities, under cabinets or through hardwood floors.
  5. Daily readings until all materials reach their drying goal.
  6. Repairs after drying, such as patching drywall, refinishing floors and painting.

If the water sat for days, for example while the home was empty, it may no longer be clean. The IICRC notes that Category 1 water can degrade over time, which changes the plan.

Where to Find Your Main Water Shutoff

Every adult in the home should know where the main shutoff valve is before a pipe ever breaks. Common locations:

Valves come in two common types. A gate valve has a round wheel handle that turns clockwise several times to close. A ball valve has a lever handle that closes with a quarter turn, when the handle is crossways to the pipe. Old valves can stick or leak when finally used, so test yours gently once in a while and have a plumber replace it if it does not close fully.

In apartments and condos, the shutoff for your unit may be inside the unit or in a shared mechanical room. Ask building management now, before you need it.

Hidden Damage to Watch For

Water from a burst pipe follows gravity and wicks sideways. Common hidden problem areas:

Because the EPA notes that mold can begin growing within 24 to 48 hours on damp materials, it is important that someone measures moisture behind surfaces, not just on them. Learn the signs of a hidden water leak.

Typical Drying Timeline

StageWhat happensWhat affects timing
Same dayWater off, plumber repair, extraction, setup of drying equipmentHow soon the leak was found
DryingEquipment runs with daily moisture readingsMaterials (hardwood and plaster dry slower), how long they were wet, humidity
RepairsDrywall, paint, flooring, cabinet workScope, insurance approval, materials

Many burst-pipe jobs dry faster than flood jobs because the water is clean and limited to the area near the break. The biggest delays come from water that was not found right away, such as a leak in an upstairs bathroom that ran for hours into the ceiling below, or a frozen pipe in a vacation home that burst while no one was there. Read more about how long drying takes.

What Can Be Saved After a Pipe Burst

With clean water and quick drying, a lot can usually be saved:

MaterialUsual outcome with fast response
Wall drywallOften dried in place unless swollen, crumbling or moldy
Ceiling drywallOften removed if it sagged or held water
InsulationWet insulation is usually removed
CarpetOften dried in place; pad sometimes replaced
HardwoodOften saved with specialty floor drying; cupping may settle as it dries
Laminate flooringOften swells and is replaced
Particleboard cabinetsOften swell and need replacement

Insurance for Burst Pipes

A pipe that bursts suddenly is the classic example of sudden and accidental water damage, which standard homeowners policies usually cover. Keep these points in mind:

Read our guides on insurance coverage and filing a water damage claim.

Cost Factors and Choosing a Company

What affects the cost: how long the water ran, how many rooms and floors it reached, ceiling and wall removal, the materials involved, equipment days, contents handling and the repair scope. Plumbing repair is usually billed separately. See our cost guide.

Choosing a company: look for technicians with IICRC certification, proof of insurance, a written scope with moisture readings and estimates your insurer can review, often written in Xactimate. Be careful before signing an assignment of benefits form. Many restoration companies offer 24/7 emergency response, which matters when water is still spreading. Call (855) 742-6216 to be connected with an independent local company.

Don't use a household vacuum on water, stand under a sagging ceiling, use a torch or open flame to thaw a frozen pipe, or turn the water back on before the pipe is repaired.

How to Prevent Frozen and Burst Pipes

To thaw a frozen pipe safely, the Red Cross recommends a hair dryer, heating pad or space heater kept away from flammable items, never an open flame.

How it works

  1. Call (855) 742-6216Tell us what happened (water, flood, mold, fire or storm) and where the property is.
  2. Get connectedWe connect your call with an independent restoration company serving your area.
  3. Get it handledThe company inspects, explains the scope in writing and works with you and your insurer. You decide whether to go ahead.

Frequently asked questions

What is the first thing to do when a pipe bursts?

Shut off the main water valve immediately. Then turn off power to wet areas if you can safely reach the breaker, open faucets to drain the lines, and stay away from sagging ceilings. Take photos, call a plumber for the pipe and a restoration company for the water damage, and report the loss to your insurer.

Does homeowners insurance cover a burst pipe?

Usually, yes, if the pipe burst suddenly. Most policies cover the resulting water damage but not the cost of repairing the pipe itself. Damage from slow, long-term leaks is usually excluded, and freeze damage may be denied if the home was not kept heated or the system was not drained while vacant. Check your policy for exact terms.

How do I know if water is inside my walls?

Signs include bubbling paint, soft or stained drywall, swollen baseboards, a musty smell and warped flooring near the wall. A restoration crew uses moisture meters and thermal imaging cameras to locate wet areas without tearing everything open. Learn more in our guide to hidden water leak signs.

Will my ceiling need to be replaced after a pipe burst?

Not always. If the ceiling only got damp and did not sag, it may dry in place. If it is sagging, holding water or has soaked insulation above it, the affected section is usually removed. Never poke a sagging ceiling yourself, as it can suddenly release a lot of water.

Can a frozen pipe burst after it thaws?

A frozen pipe often cracks while frozen, but the leak shows up once the ice melts and water flows again. That is why you should watch closely while thawing a pipe, keep the faucet open and be ready to shut off the main valve. If the pipe is in a wall or ceiling, call a plumber.

Do I need a plumber or a restoration company?

Usually both. A plumber repairs the broken pipe. A restoration company extracts the water, finds hidden moisture and dries the structure to prevent mold and further damage. Some companies coordinate both. Our referral service connects you with a local restoration company; you can call (855) 742-6216.

Related guides

Burst Pipe Water Damage by city

All 4,173 locations →

Other restoration services

Get restoration help

Water, flood, mold, fire, smoke and storm damage. Many local companies answer around the clock.

Call (855) 742-6216
Call (855) 742-6216